Code Search

Please fill the "Code Box" to find engine fault code.

Car Models :

Please select your car.

How To Clear Check Engine Lights ?

Ways to clear check engine light on car panel.

Check Engine Light Dictionary

Ways to clear check engine light on car panel.

B1062 Engine Trouble Code

Meaning of B1062 engine trouble code is a kind of body trouble code and theoretically you can drive for a few weeks or even months with a broken MAF sensor. You will notice a decrease in gas mileage and over time the car will eventually start stalling a lot. At a shop, the replacement cost is between $240-$400 depending on the car, but that's usually the cost of parts because the labor is relatively simple.

B1062 Fault Symptoms :

Check engine light comes on
Engine stalling or misfiring
Engine performance issues
Car not starting

If one of these reasons for B1062 code is occuring now you should check B1062 repair processes.
Now don't ask yourself; What should you do with B1062 code ?
The solution is here :

B1062 Possible Solution:

Power Steering Pressure (PSP) Switch Malfunction In Key On, Engine Off Self-Test, this DTC indicates the PSP input to the PCM is high. In Key On, Engine Running Self-Test, this DTC indicates that the PSP input did not change state. Steering wheel must be turned during Key On, Engine Running Self-Test PSP switch/shorting bar damaged SIG RTN circuit open PSP circuit open or shorted to SIGRTN PCM damaged.

B1062 Code Meaning :

B	1	0	6	2
OBD-II Diagnostic Body (B) Trouble Code For Engine	Fuel And Air Metering	Ambient Air Temperature Sensor Circuit Low	Cylinder 4 Contribution/Balance Fault	Glow Plug/Heater Circuit 'A' Malfunction

The poor running symptoms are consistent with a MAP sensor malfunction. In addition, in some cases, a bad MAP sensor will not throw a code. Again, the ELD code likely represents a separate wiring issue.

B1062 OBD-II Diagnostic Body (B) Trouble Code Description

B1062 engine trouble code is about Glow Plug/Heater Circuit 'A' Malfunction.

Main reason For B1062 Code

The reason of B1062 OBD-II Engine Trouble Code is Ambient Air Temperature Sensor Circuit Low.

B1062 DTC specifically refers to the camshaft (cam) timing. In this case, if the cam timing is over-retarded, the engine light will be illluminated and the code will be set.

	Example: 0140